GEPRC ELRS Nano Receiver 2.4G
GEPRC ELRS Nano Receiver 2.4G
GEPRC ELRS Nano receiver is a new generation remote control system developed based on the ExpressLRS open source project. ExpressLRS sets new standartds for long-range connection, low latency and maximum refresh rate of 500Hz.
GEPRC ELRS Nano receivers are available in 915/868MHz and 2.4GHz versions with maximum refresh rate of 500Hz and can be used with GEPRC ELRS-series products or other ELRS-compatible devices.
Specs:
- Size: 16.8mm*10mm
- Weight: 0.6g(receiver only)
- Frequency band: 915MHz FCC/868MHz EU/2.4GHz ISM
- Input voltage：5V
- Antenna connector: ipex1
Includes:
- 1 x Receiver
- 1 x T antenna
- 2 x Heat shrink tube
- 4 x Silicone cable（black, red, yellow, green）
- 1 x Pin (4pin)
- 1 x Instruction manual
Instructions
ELRS Nano receiver and FC connection diagram:
Open Betaflight Configurator, go to “Ports”tab and enable the corresponding UART as a Serial Rx (e.g. UART2 as shown below). Save and restart.
On the“Configuration”tab, click on“Serial-based receiver”on the“Receiver”panel, and select “CRSF”
Binding
1. The receiver is powered on and off for three consecutive times (within an interval of 1 second);
2. Receiver’s LED doing double flashing, indicating that the receiver has entered the binding mode;
3. Make the RF Tx module or radio transmitter enter binding status. Once the LED status changes to solid light, the binding is successful.
