RotorFlight F722V2 Gyroscope Built-In ELRS Receiver

RotorFlight F722V2 Gyroscope Built-In ELRS Receiver

FlyDragon gyro uses the open-source Rotorflight firmware, which is based on Betaflight 4.3, and has all the great features of the Betaflight platform, as well as the many new features added to the helicopter, Rotorflight also borrowed ideas and code from Heliflight3D.

Specifications:

Flight modes:self-stabilizing mode, semi-self-stabilizing mode, 3D mode, rescue mode.

Main control: STM32F722RET6

Gyroscope: BMI270

Black Box: W25N01G (128MB)

Barometer: SPL06

Color light: WS2812

Buzzer: 5V active buzzer

USB：Type-C

Serial ports: UART2, UART3, UART5

I2C：I2C1

ADC：ADC1（12S）

Servo Channel: CH1-CH4

RPM input: RPM_E (ESC RPM line), RPM_S (RPM sensor)

Built-in receiver: ELRS dual antenna receiver 2.4G (serial port 1)

External receivers: CRSF, S.BUS, F.PORT, GHOST, SUMD, SUMH, IBUS, XBUS, XBUS/RJ01, EXBUS, PPM, MSP, DSM (with its own BEC step-down 3.3V power module)

BEC voltage: 5-15V

5V power output: 5V-1.5A

ESC protocols: PWM, ONESHOT125, ONESHOT42, MULTISHOT, BRUSHED, DSHOT150, DSHOT300, DSHOT600, PROSHOT

Support ESC return: BLHeli32, Hobbywing V4, Hobbywing V5, Scorpion, Kontronik, OMPHobby, ZTW, APD

Size：45mmx27mmx14.5mm

Weight：27g

Disclaimer:

Rotorflight is open-sourced software, no warranty or implied as to the quality and reliability of this firmware, it is supported by the users themselves as a community.Rotorflight is under GPLv3 license.

If handled incorrectly, RC models can cause serious injury or even death, and you are solely responsible for your model if you decide to use Rotorflight firmware. Any injury or damage caused by the use of Rotorflight firmware is not the responsibility of the authors of Rotorflight, the designers of RF gyroscopes, or the distributors, so please use with caution.