Flywoo GOKU HD745 EVO 40A AIO Flight Controller
The Flywoo GOKU GN745 EVO HD 40A AIO Flight Controller is part of FLYWOO's new EVO series, which aims to make AIOs the new thing in FPV. Looking at the features, it is hard to resist everything on one board!
This AIO uses a powerful F745 BGA chip and BLHELI_32 ESC firmware, integrated 5V/9V dual BEC, barometer, black box, WS2812LED, supports 7 complete hardware serial ports, I2C, and other functions are available all on this 20x20 board.
Perfect for ultralight quads that need a low-profile 20x20 FC that doesn't skimp on features.
Note: Works for both DJI and analog FPV setups. Note wiring configuration at the bottom of the page.
Features:
F745 BGA chip and BLHELI_32 ESC firmware
Supports 7 complete hardware serial ports
Integrated 5V/9V Dual BEC
Black Box Feature
Specification:
HDF745 EVO Flight Controller
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART)
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only.
MCU: STM32F745 32-bit processor,216MHz, 512Kbytes Flash
Mounting Holes: Standard 20mm square to the center of holes
PPM and PWM receivers are not supported.
Onboard 8Mbytes for Blackbox logging
7 hardware UARTS (UART1,2,3,4,5,6,7)
Onboard LED:WS2812*4
3.3V Power Out: 0.5A max
9V Power Out: 1.5A max
5V Power Out: 2.0A max
Dimensions: 41x32mm
IMU: MPU6000 (SPI)
Barometer: BMP280
Weight: 8.5g
Built-in 40A BL_32 4in1 ESC
Support PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600,Dshot1200
Support BLheli / BLHELI_32
Continuous Current: 40A
Input Voltage: 2-6S Lipo
Firmware: BLHELI_32